The Nitrosomonas Bacteria consumes ammonia and produces nitrites. In the beginning, there is an excellent increase in ammonia. As new tanks do not have colonies of microbes providing biological filtration, the tank must have the cycle. Understanding Nitrogen CycleĮstablishing nitrogen cycle is very important in a newly set up aquarium. If the nitrate level is 0, then it is the ideal situation, and you do not have to change it. For the tetra fish tank, you will need the nitrate level to be around less than 40 ppm. Water changes are the way in which you may be able to lower the nitrate level. Therefore, it is best to keep the nitrate level to the minimum as well. Nitrates might also cause stress in your aquarium species. You may also see your tank water turn green. However, having nitrate means seeing the growth of algae. It is common for you to detect some traces of nitrate in your tetra aquarium. The bacteria break down the ammonia into nitrites and convert the nitrites into nitrates. This makes it bearable for tetras to have some presence of the nitrates in the tank. Nitrate is the least toxic chemical among the nitrogen compounds. The final stage of the nitrogen cycle is maintaining the nitrate level. However, the ideal nitrite level should be 0 ppm. A slight increase in the nitrite level to 0.5 ppm is tolerable. Tip: If at any time during construction you have trouble with the tape not sticking to the glass, just clean the area with some acetone on a paper towel and try again.Due to this, the nitrite level in your tetra tank should be 0 ppm. If during assembly you run out of pieces of tape, before installing another panel, cut some more pieces. Stick them to anything close by within easy reach that has a clean surface to it, and that the tape won't stick too much to, with at least half of the tape hanging down freely. Once the pieces of glass are cut, using the emery cloth or silicon carbide sandpaper, buff all the raw edges of the glass just enough to take off the sharpness.Ĭlean all the glass pane joint areas and edges about 1/2 inch inward (any place where silicone will be applied) with acetone on a paper towel.Ĭut 16 strips of duct tape, about 5 inches long. #DRAW A FISH AND FIND IT IN THE VIRTUAL AQUARIUM INSTALL#For extra strength you can pancake and glue two brace pieces together using silicone, or particularly for longer tanks, install two separate brace pieces of glass equal distances from each end of the tank.īefore starting the assembly of the aquarium you need to first get items ready for use and learn about the following important points of construction. This can be done by cutting a six-inch-wide piece of glass measured to fit the "outside" edges of the front and back panels, then attaching it into place with silicone. For a larger aquarium above 30 gallons in size, it is recommended that you install at least one "support brace" at the center of the tank.Emery cloth or silicone carbide sandpaper.All-Glass Brand 100 Percent Silicone Sealant or a similar type product is recommended. Non-toxic 100 percent silicone sealant.Do not put a solid glass cover on top of an aquarium, as this restricts the oxygen-carbon dioxide gas exchange efficiency, resulting in poor or inadequate aeration of the aquarium.Īside from one bottom, one front, one back, and two end pieces of glass, you will need the following items to construct your aquarium. Undoubtedly you will be putting a lighted hood on your tank, so design it accordingly.Use precise measurements to ensure a proper fit and help avoid leaks. #DRAW A FISH AND FIND IT IN THE VIRTUAL AQUARIUM PROFESSIONAL#If you do not feel comfortable with cutting glass, have a professional glazier cut and prepare the pieces for you.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |